The Model 110 Standalone Detector chassis can mount any combination of up to four detectors that would fit on either the SRI 8610C or 310 GC standard mainframes. The Model 110 is equipped with a heated transfer line for connection to the host GC, which may be an SRI GC or a GC from HP, Varian, PE, or any other manufacturer. Because the transfer line connects to the host GC through a very small hole in the host GC's oven, it is easy to add additional detectors to any model, even older, out of production units. Inert fused silica-lined stainless steel tubing is used exclusively.

The Model 110 is 8.5"( 21.6 cm ) wide, 14.5" ( 36.8cm ) deep and 13.5" ( 34.3cm ) high. It weighs from 10-30 lbs (4-15kg) depending on detectors installed. If the detectors installed require support gases such as hydrogen or air, the Model 110 is then equipped with electronic pressure regulators ( EPC ) for each gas. An optional air compressor may be installed to provide air for the FID, DELCD, and/or FPD detectors. The PeakSimple data system, either single or 4 channel types, may be installed for PC-based data acquisition, or the standard analog signal cable output ( 0-5 volts ) may be connected to your existing data system, integrator, or strip chart recorder.

Model 110 chassis standard equipment: heated transfer line, "at a glance display" of all detector temperatures, voltages, and pressures, and analog signal cable for connection to data system. To completely configure the Model 110, users will need to specify a detector or combination of detectors to be mounted on the chassis.

Send mail to Webmaster@quadrexcorp.com with questions or comments about this web site.
Copyright © 2002 Quadrex Corporation
Web Site Designed By Bob White From Duet Productions Ltd.