 |
 |





 |
 |
SRI GC DETECTOR
OPTIONS
|
Fourteen detector combinations are available for
mounting on the SRI Models 8610C and 310 GC
mainframes. You can also upgrade your current GC
or add more analytical power to your lab with
these detectors as Stand-Alone units on the
Model 110 detector chassis.
Up to six detectors may
be mounted along the right hand side of the
8610C GC's column oven and used simultaneously
(although some rare combinations of detectors
may conflict because of space limitations). Each
detector is equipped with a thermostatted heater
block for temperature stability, electronic
pressure controlled (EPC) support gases, such as
hydrogen and air for the FID, and internal
amplifier electronics. Select your detector
type(s) based on your particular measurement
application, detection limit required, matrix
interferences, and/or regulatory guidelines.
All detectors require factory installation. |
 |
|
SRI GC -
DETECTOR OPTIONS |
CCD, CATALYTIC COMBUSTION DETECTOR
 |
MORE INFORMATION |
TCD, THERMAL CONDUCTIVITY DETECTOR
 |
MORE INFORMATION |
FID, FLAME IONIZATION DETECTOR
 |
MORE INFORMATION |
DELCD, DRY ELECTROLYTIC CONDUCTIVITY DETECTOR
 |
MORE INFORMATION |
FID/DELCD, COMBINED FID/DELCD
DETECTOR
 |
MORE INFORMATION |
HID, HELIUM IONIZATION DETECTOR
 |
MORE INFORMATION |
PID, PHOTO IONIZATION DETECTOR
 |
MORE INFORMATION |
NPD, NITROGEN-PHOSPHOROUS DETECTOR
 |
MORE INFORMATION |
NPD/DELCD, COMBINED NPD/DELCD DETECTOR
 |
MORE INFORMATION |
TID, THERMIONIC IONIZATION DETECTOR
 |
MORE INFORMATION |
FPD, FLAME PHOTOMETRIC DETECTOR
 |
MORE
INFORMATION |
FPD/FID, COMBINED FPD/FID DETECTOR
 |
MORE
INFORMATION |
DUAL FPD, DUAL FPD PLUS FID DETECTOR
 |
MORE
INFORMATION |
ECD, ELECTRON CAPTURE DETECTOR
 |
MORE
INFORMATION |
RGD, REDUCTION GAS DETECTOR
 |
MORE
INFORMATION |
| |
|
|
SRI MODEL 110
STAND-ALONE DETECTOR CHASSIS |
|
 |
Connects to any make/model GC |
 |
Add up to four detectors to any GC |
 |
Heated transfer line for connection to
host GC |
 |
Small footprint for your lab bench |
The Model 110
Standalone Detector chassis can mount any
combination of up to four detectors that would
fit on the SRI 8610C or 310 GC standard
mainframes. The Model 110 is equipped with a
heated transfer line for connection to the host
GC, which may be an SRI GC or a GC from HP,
Varian, PE, or any other manufacturer.
|
 |
Because the transfer line connects to the host
GC through a very small hole in the host GC's
oven, it is easy to add additional detectors to
any model, even older, out of production units.
Inert fused silica-lined stainless steel tubing
is used exclusively.
|
|
The Model 110 is 8.5"( 21.6 cm ) wide, 14.5" (
36.8cm ) deep and 13.5" ( 34.3cm ) high. It
weighs from 10-30 lbs (4-15kg) depending on
detectors installed. If the detectors installed
require support gases such as hydrogen or air,
the Model 110 is then equipped with electronic
pressure regulators ( EPC ) for each gas. An
optional air compressor may be installed to
provide air for the FID, DELCD, and/or FPD
detectors. The PeakSimple data system, either
single or 4 channel types, may be installed for
PC-based data acquisition, or the standard
analog signal cable output ( 0-5 volts ) may be
connected to your existing data system,
integrator, or strip chart recorder.
Model
110 chassis standard equipment: heated
transfer line, "at a glance display" of all
detector temperatures, voltages, and pressures,
and analog signal cable for connection to data
system. To completely configure the Model 110,
users will need to specify a detector or
combination of detectors to be mounted on the
chassis.
|
#SRI-0110-0003-1, MODEL 110 CHASSIS,
120V |
$1,795.00 |
|
#SRI-0110-0003-2, MODEL 110 CHASSIS,
220V |
$1,795.00 |
|
NOTE: This is the detector chassis
only. Appropriate detectors must
be added. |
|
| |
|
|
|
 |
|
Hot Tip
|
 |
|
UP TO FIVE DETECTORS CAN BE MOUNTED ON THE 8610C GC MAINFRAME,
AND UP TO FOUR DETECTORS CAN BE MOUNTED ON THE
310 GC MAINFRAME. |
|
 |
|
Hot Tip #2 |
 |
|
NEED MORE DETECTOR CAPACITY? NEED TO ADD A NEW DETECTOR TO YOUR
EXISTING GC, REGARDLESS OF MAKE OR MODEL?
CONSIDER THE MODEL 110 STAND-ALONE DETECTOR
CHASSIS, WHICH CAN BE CONNECTED TO ANY MAKE OR
MODEL GC. |
|
 |
|
 |